MAXDATA SN 40 M1 Instructions d'exploitation télécharger pdf (Page 24)

Operation

Possible characters

The following characters can be entered:

Space

+ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghijklmnopqrstuvwxyz0123456789/\%°

+-.;

:*() followed by return symbol (arrow to left)

5.3.3 Disabling the programming mode

User code

The configuration can be protected against unintentional access by means of a four-digit code.

This code is defined in the submenu "Parameter/User Code". All the parameters remain visible

on the display but the "key" symbol is shown on the display. If you then want to change a

parameter, you first have to set the valid user code.

Hardware locking

In addition, configuration can also be locked using a connector on the rear of RIA452 (see

drawing). This is indicated by the "padlock" symbol on the display.

To hardware-lock the measuring instrument, insert the jumper into position J1 in the top

right-hand corner on the rear of the instrument.

G09-RIA452ZZ-19-00-00-xx-004

Fig. 13: Position of the jumper on the rear of the instrument

Note!

Hardware locking has no effect on the PC operating software Readwin

2000.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 79 80

Pas de commentaire

MAXDATA SN 40 M1 Instructions d'exploitation Page 24