MAXDATA VISION 450T Manuel d'utilisateur télécharger pdf (Page 47)

4-4

USER`S MANUAL

8. Lift up the mental HDD tray ‘til an angle of approximately

30 degrees and pull it up as the following illustration.

9. Note the orientation of the HDD module connector-A and

carefully remove it from the hard disk drive. (Refer to the

illustration <4-2> shawn as next page)

10. Locate and remove the rest 2 fixing screws, F and G,

securing the metal HDD tray and HDD.

11. Remove the mental HDD tray from the HDD Module.

Note the green PC board of the hard disk drive is facing

down.

12. Now you may place the new drive unit on the mental tray

and replace the fixing screws, B, C, F and G.

Hard Disk

Drive Module

Connecter-A

Flexible PCB

Modem Module

Inserted PCMCIA Card

Hard Disk

Drive Module

Fixing Screws F,G

(at the side of the metal

tray)

Illustation 4-1

Mental HDD

Tray

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Pas de commentaire

MAXDATA VISION 450T Manuel d'utilisateur Page 47