MAXDATA PLATINUM 100 I M7 Manuel d'utilisateur télécharger pdf (Page 19)

MF 19MAXDATA PLATINUM 100 I M7Server Utilities

4 Server Utilities

Using the BIOS Setup Utility

This section describes the BIOS Setup Utility options, which is used to change server configuration

defaults. You can run BIOS Setup with or without an operating system being present.

Starting Setup

You can enter and start BIOS Setup under several conditions:

• When you turn on the server, after POST completes the memory test

• When you have moved the CMOS jumper on the server board to the “Clear CMOS” position

(enabled)

In the two conditions listed above, during the Power On Self Test (POST), you will see this prompt:

Press <F2> to enter SETUP

In a third condition, when CMOS/NVRAM has been corrupted, you will see other prompts but not

the <F2> prompt:

Warning: CMOS checksum invalid

Warning: CMOS time and date not set

In this condition, the BIOS will load default values for CMOS and attempt to boot.

If You Cannot Access Setup

If you are not able to access BIOS Setup, you might need to clear the CMOS memory. For instructions

on clearing the CMOS, see “Clearing the CMOS”.

Setup Menus

Each BIOS Setup menu page contains a number of features. Except for those features that are

provided only to display automatically configured information, each feature is associated with a

value field that contains user-selectable parameters. These parameters can be changed if the user

has adequate security rights. If a value cannot be changed for any reason, the feature’s value field

is inaccessible.

1 2 ... 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

MAXDATA PLATINUM 100 I M7 Manuel d'utilisateur Page 19